DCS WDU models Spécifications télécharger pdf (Page 265)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

#DNS – Manual DNS Selection

“xxx.xxx.xxx.xxx” used for the specified cid; we’re using

this value instead of the secondary DNS server come from

the network (default is “0.0.0.0”).

Note: if <primary> is ”0.0.0.0.0” and <secondary> is not “0.0.0.0”, then

issuing AT#DNS=… raises an error.

Note: if <primary> is ”0.0.0.0.0” we’re using the primary DNS server

come from the network as consequence of a context activation.

Note: if <primary> is not ”0.0.0.0” and <secondary> is “0.0.0.0”, then

we’re using only the manual primary DNS server.

Note: the context identified by <cid> has to be previously defined, elsewhere

issuing AT#DNS=… raises an error.

Note: the context identified by <cid> has to be not activated yet, elsewhere

issuing AT#DNS=… raises an error.

AT#DNS?

Read command returns the manual DNS servers set either for every

defined PDP context and for the single GSM context (only if defined), in the

format:

[#DNS: <cid>,<primary>,<secondary>[<CR><LF>

#DNS: <cid>,<primary>,<secondary>]]

AT#DNS=?

Test command reports the supported range of values for the <cid>

parameter.only, in the format:

#DNS: (1-5),,

3.5.7.4.11. Socket TCP Connection Time-Out - #SKTCT

#SKTCT - Socket TCP Connection Time-Out

AT#SKTCT=

[<tout>]

Set command sets the TCP connection time-out for the first CONNECT

answer from the TCP peer to be received.

Parameter:

<tout> - TCP first CONNECT answer time-out in 100ms units

10..1200 - hundreds of ms (factory default value is 600).

Note: this time-out applies only to the time that the TCP stack waits for the

CONNECT answer to its connection request.

Note: The time for activate the GPRS and resolving the name with the DNS

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 317 318

Pas de commentaire

DCS WDU models Spécifications Page 265