DCS WDU models Spécifications télécharger pdf (Page 230)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

#GAUTH - PPP-GPRS Connection Authentication Type

AT#GAUTH=

[<type>]

Set command sets the PPP-GPRS connection authentication type.

Parameter

<type>

3 – AUTO authentication (PAP and CHAP , factory default)

Note: for PPP passive mode , <type> is fixed to AUTO.

AT#GAUTH? Read command reports the current PPP-GPRS connection authentication

type, in the format:

#GAUTH: <type>

AT#GAUTH=? Test command returns the range of supported values for parameter

<type>.

3.5.7.1.86. RTC Status - #RTCSTAT

#RTCSTAT - RTC Status

AT#RTCSTAT=

[<status>]

Set command resets the RTC status flag.

Parameter:

0 - Set RTC Status to RTC HW OK

Note: the initial value of RTC status flag is RTC HW Error and it doesn’t

change until a command AT#RTCSTAT=0 is issued.

Note: if a power failure occurs and the buffer battery is down the RTC

status flag is set to 1. It doesn’t change until command AT#RTCSTAT=0 is

issued.

AT#RTCSTAT? Read command reports the current value of RTC status flag, in the

format:

#RTCSTAT: <status>

AT#RTCSTAT=? Test command returns the range of supported values for parameter

3.5.7.1.87. GSM Antenna Detection - #GSMAD

#GSMAD - GSM Antenna Detection

AT#GSMAD=

<mod>,

[<urcmode>

[,<interval>

Set command sets the behaviour of antenna detection algorithm

Parameters:

<mod>

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 317 318

Pas de commentaire

DCS WDU models Spécifications Page 230