DCS WDU models Spécifications télécharger pdf (Page 63)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

3.5.3.7.10. Delay To DTR Off - S25

S25 -Delay To DTR Off

ATS25=[<time>] Set command defines the amount of time, in hundredths of second, that the

device will ignore the DTR for taking the action specified by command &D.

Parameter:

<time> - expressed in hundredths of a second

0..255 - factory default value is 5.

Note: the delay is effective only if its value is greater than 5.

ATS25? Read command returns the current value of S25 parameter.

Note: the format of the numbers in output is always 3 digits, left-filled with

3.5.3.7.11. Disconnect Inactivity Timer - S30

S30 -Disconnect Inactivity Timer

ATS30=[<tout>] Set command defines the inactivity time-out in minutes. The device

disconnects if no characters are exchanged for a time period of at least

<tout> minutes.

Parameter:

<tout> - expressed in minutes

0 - disabled, disconnection due to inactivity is disabled (factory default).

1..127 - inactivity time-out value

ATS30? Read command returns the current value of S30 parameter.

Note: the format of the numbers in output is always 3 digits, left-filled with

3.5.3.7.12. Delay Before Forced Hang Up - S38

S38 -Delay Before Forced Hang Up

ATS38=[<delay>] Set command sets the delay, in seconds, between the device’s receipt of H

command (or ON-to-OFF transition of DTR) and the disconnect operation.

Parameter:

<delay> - acknowledge timer in units of seconds

0..254 - the device will wait <delay> seconds for the remote device to

acknowledge all data in the device buffer before disconnecting

(factory default value is 20).

255 - the device doesn’t time-out and continues to attempt to deliver data

in the buffer until the connection is lost or the data is delivered.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 317 318

Pas de commentaire

DCS WDU models Spécifications Page 63