DCS WDU models Spécifications télécharger pdf (Page 237)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

3.5.7.1.95. Data Port Path - #DAPT

#DAPT – Data Port Path

AT#DAPT= <psd

port>[,<csd port>]

Set command sets the port to transmit and receive data when data call is

connected by ATD command

Parameter

<psd_port> - packet switched data port

0 – The port ATD is issued ( factory default )

1 – UART Data Port

2 – Telit USB Modem Port

3 – Telit USB Auxiliary Port

<csd_port> - circuit switched data port

0 – The port ATD is issued ( factory default )

1 – UART Data Port

2 – Telit USB Modem Port

3 – Telit USB Auxiliary Port

AT#DAPT Read command reports current setting value , in the format:

#DAPT: <psd_port>,<csd_port>

AT#DAPT=? Test command reports the supported range of values for parameter

<psd_port> and <csd_port>

Note

This command have no effect on the behavior of FAX call.

3.5.7.1.96. Apply to New Operator Names

#PLMNMODE – Apply to New Operator Names

AT#PLMNMODE=<

mode>

Set command apply to new operator names depending on the parameter

<mode>.

Parameter:

<mode>

0 – previous operator names(factory default)

1 – new operator names

Note : if <mode>=1, AT+COPN command shows new operator names.

Note: Default value for UC864-G AT&T (08.01.127) is 1.

AT#PLMNMODE? Read command returns current value of the parameter <mode>.

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 317 318

Pas de commentaire

DCS WDU models Spécifications Page 237