DCS WDU models Spécifications télécharger pdf (Page 229)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

#SKIPESC - Skip Escape Sequence

<mode>

0 - doesn’t skip the escape sequence; its transmission is enabled (factory

default).

1 - skips the escape sequence; its transmission is not enabled.

Note: in case of an FTP connection, the escape sequence is not transmitted,

regardless of the command setting.

AT#SKIPESC? Read command reports whether escape sequence skipping is currently

enabled or not, in the format:

#SKIPESC: <mode>

AT#SKIPESC=? Test command reports supported range of values for parameter <mode>.

3.5.7.1.84. Escape Sequence Guard Time - #E2ESC

#E2ESC - Escape Sequence Guard Time

AT#E2ESC=

[<gt>]

Set command sets a guard time in seconds for the escape sequence in

GPRS to be considered a valid one (and return to on-line command mode).

Parameter:

<gt>

0 - no guard time (factory default)

1..10 - guard time in seconds

Note: if the Escape Sequence Guard Time is set to a value different from

zero, it overrides the one set with S12.

AT#E2ESC? Read command returns current value of the escape sequence guard time,

in the format:

#E2ESC: <gt>

AT#E2ESC=? Test command returns the OK result code.

3.5.7.1.85. PPP-GPRS Connection Authentication Type - #GAUTH

#GAUTH - PPP-GPRS Connection Authentication Type

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 317 318

Pas de commentaire

DCS WDU models Spécifications Page 229