DCS WDU models Spécifications télécharger pdf (Page 174)

UC864-E/G/WD/WDU AT Commands Reference Guide

80304ST10041a Rev. 7 - 2010-10-14

3.5.7.1.8. Change Audio Path - #CAP

#CAP - Change Audio Path

AT#CAP=[<n>] Set command switches the active audio path depending on parameter <n>

Parameter:

<n> - audio path

0 - audio path follows the AXE input (factory default):

 if AXE is low, handsfree is enabled;

 if AXE is high, internal path is enabled

1 - enables handsfree external mic/ear audio path

2 - enables internal mic/ear audio path

Note: The audio path are mutually exclusive, enabling one disables the

other.

Note: when changing the audio path, the volume level is set at the

previously stored value for that audio path (see +CLVL).

AT#CAP? Read command reports the active audio path in the format:

#CAP: <n>.

AT#CAP=? Test command reports the supported values for the parameter <n>.

3.5.7.1.9. Open Audio Loop - #OAP

#OAP – Open Audio Loop

AT#OAP=

<mode>

Set command sets Open Audio Path.

Parameter:

0 - disables Open Audio Path (default)

1 - enables Open Audio Path

Note: This parameter is not saved in NVM

AT#OAP? Read command returns the current Open Audio Path, in the format:

#OAP: <mode>

AT#OAP =? Test command returns the supported range of values of parameter

<mode>.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 317 318

Pas de commentaire

DCS WDU models Spécifications Page 174