UC864-E/G/WD/WDU AT Commands Reference Guide
80304ST10041a Rev. 7 - 2010-10-14
Reproduction forbidden without Telit Communications S.p.A’s. written authorization - All Rights Reserved. Page 133 of 318
+CGDATA - Enter Data State
"PPP" - PPP Point-to-point protocol
<cid> - numeric parameter which specifies a particular PDP context
definition (see +CGDCONT command).
Note: if parameter <L2P> is omitted, the layer 2 protocol is unspecified
AT+CGDATA=? Test command reports information on the supported layer 2 protocols.
Example AT+CGDATA=?
+CGDATA: (”PPP”)
OK
AT+CGDATA=”PPP”,1
OK
Reference 3GPP TS 27.007
Commentaires sur ces manuels