Dcs C-24W Manuel d'utilisateur télécharger pdf (Page 13)

BACKGUARD INSTALLATION

The backguard must be installed when there is less than a 12” clearance between combustibles and back edge of

wok. For island installations and other installations with over 12” clearance, an optional stainless steel trim

channel is available to cover the backguard mounting flanges.

Refer to Fig.13

A. Slide backguard over the 2 flanges on the rear of the appliance. Fasten the back with two screws (See A Fig.13)

provided. No screws are required behind the wok section.

B. Fasten the top of the backguard to the wall with two screws through the backguard (See ‘A’, Fig. 13).

C. Place the backguard cap on top and fasten using the two counter-sunk screws provided (See ‘B’, Fig. 13).

Fig. 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Pas de commentaire

Dcs C-24W Manuel d'utilisateur Page 13