DCS WD-30-BL Informations techniques télécharger pdf (Page 114)

Advanced Configuration

Tsunami

8000 Series - Software Management Guide 114

Figure 5-50 Edit a Mapped Profile

Make the necessary edits, and click OK followed by COMMIT.

: When the radio mode is changed (say BSU to SU, or SU to BSU), the link profiles and the peer profile mapping list is

retained.

5.5 Security

5.5.1 Wireless Security

The Wireless Security feature helps to configure security mechanisms to secure the communication link between a BSU and

an SU, and a link between End Point A and End Point B. By default, the default security is WORP Security. A maximum of

eight security profiles can be created as required; however, only one security profile can be active at a time. The active security

profile is configured as part of the WORP property Security Profile Name. For a security profile to be active, it must be

enabled. Refer to Wireless Outdoor Router Protocol (WORP) for more details.

: Configure the same security profile on the either ends to establish a connection.

To configure the Wireless security profile, navigate to ADVANCED CONFIGURATION > Security > Wireless Security. The

Wireless Security Configuration screen appears:

Figure 5-51 Wireless Security Configuration

Given below is the table which explains Wireless Security parameters:

Parameter Description

Profile Name Specifies the security profile name. By default, it is WORP Security.

Entry status Enables a user to either Enable or Disable the security profile on the device. By default, it

is enabled.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 309 310

Pas de commentaire

DCS WD-30-BL Informations techniques Page 114