DCS RF15IR1 Manuel d'utilisateur télécharger pdf (Page 16)

INSTALLATION INSTRUCTIONS

Connecting the water supply

Water supply

Connect the ice maker to a potable drinkable water supply only. Do not install on line

pressure above 120psi (827kPa) or below 20psi (138kPa).

Use 1/4” (6mm) copper tubing for your water supply line, available at any local hardware

or plumbing supply store. Purchase enough copper tubing to allow a coil to be formed

behind the unit so the appliance can be pulled out from the installation for servicing

or cleaning (B). Route the 1/4” (6mm) copper tubing (water supply line) to suit your

installation being sure not to kink the tubing.

A shutoff valve is recommended on the water supply line to ease servicing the

appliance. Do not use a self-piercing type valve.

Water supply inlet

connection to shut off valve

1/4’’ copper tubing

(water supply line)

Compression nut fitting

Water supply line

Water valve inlet

D Screw and clamp

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Pas de commentaire

DCS RF15IR1 Manuel d'utilisateur Page 16