DCS HD30 Manuel d'utilisateur télécharger pdf (Page 23)

INSTALLATION INSTRUCTIONS

Prepare for electrical connection

Downdraft unit



Remove the cover of the terminal box from the downdraft unit Fig.21.



Decide whether the power source should enter the downdraft unit from below or

from the back and remove the respective knock out. Install a UL listed strain relief or

conduit fitting (not included) in the knock out Fig.22.



If the downdraft unit is being installed with a remote blower, remove the knock out

for the control cable.



With the assistance of another person, lift the downdraft unit into the prepared cutout in

the cabinet. The over counter mounting brackets should rest on the countertop.



Secure the downdraft unit to the floor and countertop with screws into the previously

drilled holes Fig.23.



Push the end caps into place on the downdraft unit on top of the counter and lock

them in place Fig.24.

FRONT

Fig.21

Fig.22

Fig.24

Fig.23

6 x

2 x

FRONT

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Pas de commentaire

DCS HD30 Manuel d'utilisateur Page 23