Dcs -DRH48N Manuel d'utilisateur télécharger pdf (Page 13)

Lighting Instructions

Operation Instructions

Upon installation of the heater and completion of the gas line and electrical supply

to each heater, follow the steps outlined in the “ lighting instructions”. “ Lighting instruc-

tions” are also provide on the control panel.

Turn gas and power to “ON”. The igniter should light within the first 4 seconds. If

not, the electrode sensor will shut-off the hot surface igniter. The igniter will attempt to

light 3 times before “ locking out”. During initial installation, this will happen if the gas line

is not purged. To reset the control, shut off the power to the unit and wait 5 seconds. Turn

power back to “ON” position. This will allow for 3 more lighting attempts.

To Start Heater

1). Turn manual gas valve to “ON” position.

2). Turn electrical supply “ON”.

To Shut Down Heater

1). Turn electrical supply “OFF”.

2). Turn manual gas valve to “OFF” position.

CAUTION: If burner fails to ignite, shut down electrical power and wait 5 minutes

before turning power “ON”. To allow any gas to dissipate.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

Pas de commentaire

Dcs -DRH48N Manuel d'utilisateur Page 13